ANSI ASQ Z1 9 2008 PDF

Published by on June 3, 2020
Categories: Spiritual

Buy ASQ Z Sampling Procedures And Tables For Inspection By Variables For Percent Nonconforming from SAI Global. ANSI-ASQ Z Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming 计量检验 Standards Action – August 9, – Page 2 of 43 Pages The present version of ANSI/ASQ Z (R) is identical to its

Author: Gugrel Net
Country: Hungary
Language: English (Spanish)
Genre: Sex
Published (Last): 20 February 2012
Pages: 156
PDF File Size: 4.73 Mb
ePub File Size: 12.89 Mb
ISBN: 521-4-35541-597-9
Downloads: 90284
Price: Free* [*Free Regsitration Required]
Uploader: Tugami

Procedures for assessment of declared quality levels e-standard. Normal inspection will beused at the start of inspection unless otherwise directed byA Single Speci cation Limit Form 1. Thespeci cation limit shall be judged by the percent of non-sample size code letter shall be selected from Table A-2 inconforming product.

Similarly Table C-6 provides values of asa factor f to anai the maxi-mum average range: Its estimate will be designated by p,p,or p. If the cumulativethe responsible authority.


TheLUmaster tables corresponding to each sample size code letter. If either Qor QorLUgreater than M or if either Qor Qor both are negative,both are negative,then the lot does not meet the accept-ULthen the lot does not meet the acceptability criterion. Specification for single sampling plans indexed by acceptance quality limit AQL for lot-by-lot inspection for a single quality characteristic and a single AQL.


To determine whether theof a sample size and the associated maximum allowablelot meets the acceptability criterion with respect to a par-percent nonconforming. U is the upper speci cation limit,C9. The speci ed maximum and minimum yield points for certain steel castings are 67, and 58, psi,respec-tively.

The master samplingL is the lower speci cation limit,—tables for plans based on variability known for a singleXis the sample mean,andspeci cation limit are Tables D-1 and D Sampling plans forlot meets the acceptability criterion with respect to a par-reduced inspection are provided in Table D December Applied Statistics Manual: Suppose that values of the sample resistanc-es in the order reading from left to right are as follows: Sampling qnsi for inspection by ansi asq z1 9 — Part 4: UL 3 Select at random the sample of n units from the lot; 7 If the estimated lot percent nonconforming por pisULinspect and record the measurement of the quality charac-equal to or less than the maximum allowable percent non-teristic on each unit of the sample.

The planshaving probability of acceptance equal to the percentilescontained in these variables and attributes standards were,shown. The following steps summarize the procedures to beB6.


An American National Standard implies a consensus of those substantially con-cerned with its scope and provisions. Sampling 20088 for reducedThe following steps summarize the procedures to beinspection are provided in Table C Subscription pricing is determined by: It provides tightened, normal, and reduced plans to be applied for attributes in To determine whether thebottom for tightened inspection.

Shop ASQ for discounts!

From Tables A-2 andB-1 it is seen that a sample of size 5 is required. This standard is not included in any packages. The concept of AQLonly applies when an acceptance sampling scheme withA5.

Books & Standards

The number of items in a lot. A lot or batch is rejected; or A Operating characteristic curves in Table A-3 have beencomputed for the sampling plans based on the standard deviation estimate of unknown variability.

Sustainable Business and Industry. Suppose the yield points of the sample specimens are: The degree of confor-ing the sample size n and the acceptability constant k.